As a member of the welded pipe industry, we often see a situation in the customer's factory, that is, the matching degree between the shaft and the bearing is not very good, it is difficult to install, and the adjustment engineer has to work hard. , then what do you do when you encounter the non-standard processing of the shaft produced by the welded pipe machinery equipment production line, and the cooperation with the bearing cannot be completed? Today, we Foshan GXG Technology Co., Ltd. will give you some popular science.

First of all, the shaft of the welded pipe machinery equipment production line is not standard. This must be dealt with from the perspective of processing, because when designing, there should be no problems with the digital marking. If it is a problem with the marking, then the follow-up problem will be much bigger. Yes, this is easy to understand. When there is a problem in the processing of the shaft, it is necessary to select some partners with processing experience and high precision processing equipment to cooperate, so that they can process products that meet the tolerance requirements.

Another situation of non-standard production spools of welded pipe machinery equipment production line is that the assembly is not good, and there may be no problems in processing, but when assembling, the angle is wrong or the size is not accurate, which will also cause poor assembly.

When the shaft and bearing of the welded pipe machinery equipment production line cannot be installed well on site, the shaft is often ground and the outer diameter of part of the shaft is reduced. After installation, this method can only be used temporarily. If it is used stably for a long time, It is recommended to replace the shaft for better construction.

Key words:welded pipe machinery equipment production line

Foshan GXG Technology Co., Ltd

web: http://www.fsgxiug.com

Tel: 86-18820879368(Wechat-Whatsapp)

E-mail： 345291578@qq.com