Many welded pipe manufacturers are concerned that replacing welding pipe mechanical equipment will waste a lot of time when replacing welded pipe molds. In fact, this concern is unnecessary and there is no objection. Since there are differences in size, there will be a problem of replacement. As long as it is replaced, it will consume time. No matter how automated or intelligent it is, it requires an interval time, but is there a better way? The answer is yes, that is to achieve partial sharing of welding pipe mechanical equipment molds. In this sharing situation, it can achieve less mold replacement and increase efficiency.

The sharing of welding pipe mechanical equipment molds is not suitable for all sizes of pipe production, but only for some or a certain range of welding pipe production. This method can be used. Generally speaking, we suggest that this method is suitable for large-diameter pipes, usually 89 caliber or above. If it is too small, it is not convenient to operate because the deformation of the steel strip will be affected.

After using a shared mold replacement method for welding pipe mechanical equipment, only a few sets of welded pipe molds need to be replaced to achieve size replacement. Not all welded pipe molds need to be replaced, which saves a lot of time and greatly increases efficiency.

Key words:welding pipe mechanical equipment

Foshan GXG Technology Co., Ltd

web: http://www.fsgxiug.com

Tel: 86-18820879368(Wechat-Whatsapp)

E-mail： 345291578@qq.com