When producing straight seam welded pipe, a necessary hardware workpiece needs to be used, that is, welded pipe mold. However, the design of welded pipe mold is different for different pipe types and models. Today, Foshan GXG Technology Co., Ltd. will discuss with you some factors that need to be considered in the bottom diameter design of welded pipe mold.

When designing the bottom diameter of welded pipe mold, we should first consider the model, because the design dimensions are different due to different models. If the bottom diameter is designed too small, there may be the situation that the upper and lower flat roll molds cannot be pressed against. This is not feasible. If it is too large, there may be the problem that they cannot be installed. These are one of the factors to be considered.

Secondly, when designing the bottom diameter of the welded pipe mold, we need to consider the situation of the pipe to be produced, especially the problem of thickness. The thicker the pipe, the stronger the welded pipe mold is required. If the bottom diameter is too small, it is easy to crack.

Finally, we should consider the molding design of welded pipe mold. Not every group of mold bottom diameter is the same, so we should pay special attention to it when producing thin-walled pipe.

If you are a welded pipe mold manufacturer, or you are a pipe manufacturer, when the welded pipe mold is not suitable for production, there may be a problem in the bottom diameter design. Now you know where to start to solve it, or if you can't, please contact Foshan GXG Technology Co., Ltd. and we will give you a solution.

Key words:welded pipe mold

Foshan GXG Technology Co., Ltd

web: http://www.fsgxiug.com

Tel: 86-18820879368(Wechat-Whatsapp)

E-mail： 345291578@qq.com