The forming design of welded pipe molds is different, some are integrated and some are split, especially for large diameter welded pipe molds. The initial forming parts in front are almost split. So why? We tube rust steel technology and everyone to see why.

The strip steel of large-diameter pipe is relatively wide, and many requirements of the initial forming part in front are to press the edges and corners at both ends of the strip steel and press out an arc, which is commonly known as arcing. As long as this is done, most of the middle parts do not need to be extruded and can be deformed slightly. For the wide surface strip steel, If you make an integrated mold, it will not be compared from the perspective of processing, cost control, or the significance of specific implementation. The effect is poor. If you change the design of components, it will be more worthwhile in all aspects.

If you need a large diameter welded pipe mold, you can contact our GXG technology to give you reasonable suggestions to get twice the result with half the effort.

Key words:large diameter welded pipe mold

Foshan GXG Technology Co., Ltd

web: http://www.fsgxiug.com

Tel: 86-18820879368(Wechat-Whatsapp)

E-mail： 345291578@qq.com