I think many people have different understandings about the problem of slow forming or fast forming of stainless steel welded pipe mould. Why do you say that? Because everyone has different perspectives. From my perspective, I certainly think that slow forming is better than rapid forming.

Reason 1: slow forming of stainless steel welded pipe mould can gradually deform the steel strip without causing too much stress. The elasticity of the steel strip will be relieved without obvious rebound.

Reason 2: the tube damage rate of slow prototyping is much smaller than that of rapid prototyping. Rapid prototyping is relatively rapid, so it is easy to have the steel strip pulled, and slow prototyping will better avoid or reduce the occurrence of such defects, so as to improve the yield.

Reason 3: the wear of stainless steel welded pipe mould by slow forming is smaller than that by rapid forming, which is to reduce the cost of loss and improve the income of the enterprise.

So in my opinion, the mold forming method of stainless steel welded pipe is better slow than fast. Of course, those who say fast and good should be from the perspective of cost. After all, the number of molds used in rapid prototyping is small, and the price will be cheaper. It depends on how customers choose.

Article by: stainless steel welded pipe mould 

http://www.fsgxiug.com Foshan Senwel technology - guanxiugang-gxiug finishing supply