We have seen pipe welding machines that produce stainless steel straight seam welded pipes, some of which drive one main motor and some of which drive two main motors, but many of the high frequency pipe welding machinery we have seen are common pipe welding machines that produce pipes with diameter less than 76, But I also met the customer's demand for two high-frequency welded pipe machines driving the main motor. If the high frequency pipe welding machinery adopts two main drive motors, is it good?

In fact, if it were me, I would also like to have two main drive motors, which is convenient for control. However, the environment in which one main drive motor has been used for high frequency pipe welding machinery for a long time. If you want to change it, it will cost some price. Compared with the single motor sung before, the power of the two main motors must be stronger, and the advantages will be obvious in the production of thick wall tubes. In addition, the speed of the front and rear sections of a single motor is the same, and it is better to speed the rear section a little faster in the production of welded pipe, so it can not be adjusted. It is not enough to use only by removing several universal joints, so it can only be improved a little. However, in terms of cost, the price of dual motor drive must be much higher than that of single motor. After all, if there is an additional motor, there will be an additional gearbox and a set of control unit. These are costs.

If your cost is not very limited, it is recommended that you choose the double drive design when purchasing high frequency pipe welding machinery, which will certainly be easier to use.

Key words:high frequency pipe welding machinery

Foshan GXG Technology Co., Ltd

web: http://www.fsgxiug.com

Tel: 86-18820879368(Wechat-Whatsapp)